Disassembly and reassembly
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Topics:
• Recommended tools
• Screw list
• Base cover
• Battery
• Memory modules
• Solid-state drive
• Coin-cell battery
• WLAN card
• Speakers
• Heat sink
• System fan
• I/O board
• System board
• DC-in port
• Power button with fingerprint reader (optional)
• Touchpad
• Display assembly
• Palm-rest and keyboard assembly
Recommended tools
The procedures in this document may require the following tools:
● Phillips #0 screwdriver
● Phillips #1 screwdriver
● Plastic scribe
NOTE: The #0 screw driver is for screws 0-1, and the #1 screw driver is for screws 2-4.
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
3
12 Disassembly and reassembly
To Next Page
