Delta AHCPU560-EN2 Series - Page 33

Chapter 4 EIP Builder
4-9
4_
3. Set up the IP address
 Select and double-click the listed address to open the IP setup page.
 Type the IP address.
4. Disable DHCP/BOOTP
 Click to select the device in the Mapping Table that you’d like to disable its DHCP/BOOTP function and
then click the Disable DHCP/BOOTP button. After that the selected device will not send DHCP/BOOTP
requests. For the modification on the IP address receiving mode, refer to section 4.2.4 for more
information.