EtherNet/IP Operation Manual
4-10
Note
1. Enable BOOTP: When the IP address receiving mode is in BOOTP (BOOTP is enabled), the IP
address is assigned, and the device will send out BOOTP requests for IP addresses during each
power-on.
2. Enable DHCP: When the IP address receiving mode is in DHCP (DHCP is enabled), the IP address
is assigned, and the device will send out DHCP requests for IP addresses during each power-on.
3. Disable DHCP/BOOTP: When the IP address receiving mode is in BOOTP (BOOTP is enabled), the
IP address is assigned; once the Disable DHCP/BOOTP button is clicked, the device will not send
out DHCP/BOOTP requests for IP addresses during each power-on.
To Next Page
Loading...