Denon AVR-4311CI - Adjusting the Volume of the Speakers

66
Convenient functions
Sleep timer function
The power automatically goes into standby once the set time has
elapsed.
This is convenient for playing sources while going to sleep.
Press SLEEP and display the time you
want to set.
The indicator on the display lights.
• The time switches as shown below each
time SLEEP is pressed.
OFF 10 min 20 30 40 50
6080 7090100
110
120
To confirm the countdown time before putting the
unit to sleep
Press SLEEP.
“Sleep : zmin” appears on the display.
z Countdown time
To cancel the sleep timer
Press SLEEP to set “OFF”.
The indicator on the display turns off.
• The sleep timer setting is canceled if this unit’s power is set to
standby.
• The sleep timer function can be set separately for the different zones
(vpage74 “Sleep timer function”).
Adjusting the volume of the speakers
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
n Adjusting the volume of the different speakers
1
Press ZONE SELECT to switch the
zone mode to
M
(MAIN ZONE).
The
M
indicator lights.
2
Press AMP to set the remote
control unit to AMP-operation
mode.
3
Press CH LEVEL.
CHANNEL LEVEL
Front L
Front R
-8.0dB
-12.0dB
Subwoofer1
Subwoofer2
Subwoofer
0.0dB
0.0dB
ON
4
Use ui to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
5
Use o p to adjust the volume.
• You can directly turn “OFF” the subwoofer outputs during
2-channel playback in DIRECT or STEREO mode.
Select “Subwoofer” and use o p to select “ON” or “OFF”.
CHANNEL LEVEL
Front L
Front R
-8.0dB
-12.0dB
Subwoofer OFF
When a headphone jack is inserted, the headphone channel level can
be adjusted.
n Adjusting the volume of groups of speakers
(Fader function)
This function lets you adjust (fade) the sound all at once from the
front (front speaker / front height speaker / front wide speaker /
center speaker) or rear (surround speaker / surround back speaker).
1
Press ZONE SELECT to switch the zone mode to
M
(MAIN ZONE).
The
M
indicator lights.
2
Press AMP to set the remote
control unit to AMP-operation
mode.
3
Press CH LEVEL.
4
Press i to select “Fader”, then
select the item to be adjusting
using o p.
CHANNEL LEVEL
Front L
Front R
-8.0dB
-12.0dB
Fader Front Rear
Front Height L
Front Height R
0.0dB
0.0dB
Front Wide L
Front Wide R
-12.0dB
-10.0dB
0.0dB
0.0dB
Subwoofer2
Surround L
Center
Subwoofer1
0.0dB
-12.0dB
Surround R -10.0dB
5
Use o p to adjust the volume of the speakers.
(o : front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker is adjusted
to the lowest value of –12 dB.
1.AVR4311CIEU_ENG_108.indd 66 2010/08/30 20:10:55