110
Appendix
TipsSettingsConnections
Contents
Front panel Display Rear panel IndexRemote
Playback
Playback in ZONE2
ZONE2
X
POWER
X
ZONE2
MUTE
ZONE2
SOURCE
ZONE2
VOLUME
1
Press ZONE2 X to turn on the ZONE2 power.
The ( indicator on the display lights.
%
•When ZONE2 X is pressed, ZONE2 turns o.
•Power in ZONE2 can be turned on or o by pressing ZONE2 ON/
OFF on the main unit.
2
Press the ZONE2 SOURCE df button to select the input
source to be played.
The audio signal of the selected source is output to ZONE2.
%
•In ZONE2, you can select iPod/USB, TUNER, NETWORK or an
input source with an analog audio input connector.
•To perform an operation with the main unit, press ZONE2
SOURCE.
Each time you press ZONE2 SOURCE, the input source changes.
2 Adjusting the volume
Use ZONE2 VOLUME df to adjust the volume.
•At time of purchase, “Volume Limit” (vpage 153) is set to “70
(–10dB)”.
%
•Turn MASTER VOLUME after pressing ZONE2 SOURCE on the main unit to
adjust the sound volume.
To Next Page
Loading...
