Denon AVR-X1000 User Manual

149
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Network
To use this unit by connecting it to a home network (LAN), you must configure network settings.
If you set up your home network (LAN) via DHCP, set “DHCP” to “On” (use the default setting). This allows this unit to use your home network (LAN).
If you assign an IP address for each device, you must use the “IP Address” setting to assign an IP address to this unit and enter the information about
your home network (LAN) such as the gateway address and subnet mask.
Information
Display network information.
Friendly Name / DHCP On or O / IP Address / MAC Address
%
•MAC Address is required to make a vTuner account.
IP Control
Enables network communication in standby power mode.
O In Standby : Suspend network function during standby.
Always On (Default) : Network is on during standby. Main unit operable
with a network compatible controller.
%
•Set to “Always On” when using the web control function.
NOTE
•When “IP Control” is set to “Always On”, it consumes more standby power.
Friendly Name
The Friendly Name is the name of this unit displayed on the network. You
can change the Friendly Name according to your preferences.
2 Edit Name
Edits Friendly Name.
%
•The default Friendly Name on first use is “Denon AVR-X1000”.
•Up to 63 characters can be input.
•For character input, see page119.
2 Set Defaults
Restores Friendly Name, which you had changed, to the default setting.

Denon AVR-X1000 Specifications

General

Receiver type	-
Frequency range	10 - 100000 Hz
Pre-out channels	1 SW
Input sensitivity	200 mV
Pre-out connectivity	Yes
Audio output channels	5.1 channels
Signal-to-Noise Ratio (SNR)	98 dB
Total Harmonic Distortion (THD)	0.08 %
Power output per channel (1KHz@6 Ohm)	145 W
Power output per channel (20-20KHz@8 Ohm)	80 W
HDMI in	5
Composite video in	2
Ethernet LAN (RJ-45) ports	1
Multichannel audio output type	RCA
Connectivity technology	Wired
AM antenna ports quantity	0
Speakers connectivity type	Binding post
Audio formats supported	AAC, FLAC, MP3, WAV, WMA
Image formats supported	JPS
Wi-Fi	No
Supported radio bands	FM
Internet radio services supported	vTuner
Product color	Black
Audio decoders	Dolby Digital EX, Dolby Pro Logic IIx, Dolby TrueHD, DTS 96/24, DTS-ES, DTS-HD Master Audio
Volume control	Rotary
Apple docking compatibility	iPhone
Number of products included	1 pc(s)
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	390 W
Cables included	AC

Weight and Dimensions

Depth	330 mm
Width	434 mm
Height	151 mm
Weight	8200 g