Denon AVR-X1000 User Manual

166
Appendix
SettingsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Tips
2 Desired sound does not come out
Symptom Cause/Solution Page
The volume does not increase. •The maximum volume is set too low. Set the maximum volume using “Limit”on the menu.
•Appropriate volume correction processing is performed according to the input audio format
and settings, so the volume may not reach the upper limit.
125,153
–
No sound comes out with the HDMI
connection.
•Check the connection of the HDMI connectors.
•When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to
“AVR”. To output from the TV, set “TV”.
•When using the HDMI control function, check that the audio output is set to the AV amplifier
on the TV.
26,27
129
104
No sound comes out of a specific
speaker.
•Check that the speaker cable is properly connected.
•Check that a selection other than “None” is set for the “Speaker Config.” setting in menu.
•When the sound mode is “STEREO” and “VIRTUAL”, audio is only output from the front
speakers and subwoofer.
21
145
–
No sound is produced from
subwoofer.
•Check the subwoofer connections.
•Turn on the subwoofer’s power.
•Set “Speaker Config.” – “Subwoofer” on the menu to “Yes”.
•When “Speaker Config.” – “Front” in the menu is set to “Large”, depending on the input
signal and the sound mode, no sound may be output from the subwoofer.
•When no subwoofer audio signal (LFE) is included in the input signals, no sound may be
output from the subwoofer.
•You can make the subwoofer always output sound by setting the subwoofer mode to
“LFE+Main”.
22
–
145
145
148
148
DTS sound is not output. •Check that the digital audio output setting on the connected device is set to “DTS”.
•Set “Decode Mode” on the menu to “Auto” or “DTS”.
–
135

Denon AVR-X1000 Specifications

General

Receiver type	-
Frequency range	10 - 100000 Hz
Pre-out channels	1 SW
Input sensitivity	200 mV
Pre-out connectivity	Yes
Audio output channels	5.1 channels
Signal-to-Noise Ratio (SNR)	98 dB
Total Harmonic Distortion (THD)	0.08 %
Power output per channel (1KHz@6 Ohm)	145 W
Power output per channel (20-20KHz@8 Ohm)	80 W
HDMI in	5
Composite video in	2
Ethernet LAN (RJ-45) ports	1
Multichannel audio output type	RCA
Connectivity technology	Wired
AM antenna ports quantity	0
Speakers connectivity type	Binding post
Audio formats supported	AAC, FLAC, MP3, WAV, WMA
Image formats supported	JPS
Wi-Fi	No
Supported radio bands	FM
Internet radio services supported	vTuner
Product color	Black
Audio decoders	Dolby Digital EX, Dolby Pro Logic IIx, Dolby TrueHD, DTS 96/24, DTS-ES, DTS-HD Master Audio
Volume control	Rotary
Apple docking compatibility	iPhone
Number of products included	1 pc(s)
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	390 W
Cables included	AC

Weight and Dimensions

Depth	330 mm
Width	434 mm
Height	151 mm
Weight	8200 g