Name: Denon AVR-X1000
Brand: Denon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Appendix

TipsSettingsPlayback

Contents

Front panel Display Rear panel IndexRemote

Connections

Speaker connection

Here we connect the speakers in the room to this unit.

This section explains how to connect them using typical examples.

NOTE

•Disconnect this unit’s power plug from the power outlet before connecting the

speakers. Also, turn o the subwoofer.

•Connect so that the speaker cable core wires do not protrude from the speaker

terminal. The protection circuit may be activated if the core wires touch the rear

panel or if the + and – sides touch each other (vpage191 “Protection circuit”).

•Never touch the speaker terminals while the power cord is connected. Doing so

could result in electric shock. When the “Setup Assistant” is running, follow the

instructions in the “Setup Assistant” screen for making connections. (Power is not

supplied to the speaker terminals while the “Setup Assistant” is running.)

•Use speakers with an impedance of 6 – 16 Ω/ohms.

2 Connecting the speaker cables

Carefully check the left (L) and right (R) channels and + (red) and –

(black) polarities on the speakers being connected to this unit, and be

sure to connect the channels and polarities correctly.

Peel o about 3/8 inch (10 mm) of

sheathing from the tip of the speaker

cable, then either twist the core wire

tightly or terminate it.

Turn the speaker terminal counterclockwise

to loosen it.

Insert the speaker cable’s core wire to the

hilt into the speaker terminal.

Turn the speaker terminal clockwise to

tighten it.

Other manuals for Denon AVR-X1000

Questions and Answers:

Need help?

Do you have a question about the Denon AVR-X1000 and is the answer not in the manual?

General

Receiver type	-
Frequency range	10 - 100000 Hz
Pre-out channels	1 SW
Input sensitivity	200 mV
Pre-out connectivity	Yes
Audio output channels	5.1 channels
Signal-to-Noise Ratio (SNR)	98 dB
Total Harmonic Distortion (THD)	0.08 %
Power output per channel (1KHz@6 Ohm)	145 W
Power output per channel (20-20KHz@8 Ohm)	80 W
HDMI in	5
Composite video in	2
Ethernet LAN (RJ-45) ports	1
Multichannel audio output type	RCA
Connectivity technology	Wired
AM antenna ports quantity	0
Speakers connectivity type	Binding post
Audio formats supported	AAC, FLAC, MP3, WAV, WMA
Image formats supported	JPS
Wi-Fi	No
Supported radio bands	FM
Internet radio services supported	vTuner
Product color	Black
Audio decoders	Dolby Digital EX, Dolby Pro Logic IIx, Dolby TrueHD, DTS 96/24, DTS-ES, DTS-HD Master Audio
Volume control	Rotary
Apple docking compatibility	iPhone
Number of products included	1 pc(s)
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	390 W
Cables included	AC