131
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
TV Format
Set the video signal format to be output for the TV you are using.
2 Format
NTSC (Default) : Select NTSC output.
PAL : Select PAL output.
%
•“Format” can also be set by the following procedure. However, the menu
screen is not displayed.
1. Press and hold the main unit’s ZONE2 SOURCE and STATUS for at least 3
seconds.
“V.Format:<NTSC>” appears on the display.
2. Use the main unit’s TUNER PRESET CH +, – and set the video signal format.
3. Press the main unit’s STATUS to complete the setting.
NOTE
•When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
To Next Page
Loading...
