EasyManuals Logo

Denon AVR-X1000 User Manual

Denon AVR-X1000
207 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
38
Appendix
TipsSettingsPlayback
Contents
Front panel Display Rear panel IndexRemote
Connections
%
•When using this unit, we recommend you use a router equipped with the following
functions:
•Built-in DHCP server
This function automatically assigns IP addresses on the LAN.
•Built-in 100BASE-TX switch
When connecting multiple devices, we recommend a switching hub with a speed
of 100 Mbps or greater.
•Use only a shielded STP or ScTP LAN cable which is easily available at electronics
stores (CAT-5 or greater recommended).
•The normal shielded-type LAN cable is recommended. If a flat-type cable or
unshielded-type cable is used, other devices could be aected by noise.
NOTE
•The types of routers that can be used depend on the ISP. Contact your ISP or a
computer shop for details.
•This unit is not compatible with PPPoE. A PPPoE-compatible router is required if
you have a contract for a type of line set by PPPoE.
•Do not connect an NETWORK connector directly to the LAN port/ Ethernet
connector on your computer.
Connecting an external control
device
REMOTE CONTROL jacks
If this unit is installed in a location that is out of range of the signal from
the remote control unit (such as when installed in a cabinet), you can still
operate the unit and the devices connected to it by using a commercially
available IR receiver.
You can also use it to remotely control ZONE2 (another room).
FRONT FRONT
CENTER SURROUNDSURROUND
AUX
OUT
Infrared
retransmitter
Infrared
sensor
Output
Input

Table of Contents

Other manuals for Denon AVR-X1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X1000 and is the answer not in the manual?

Denon AVR-X1000 Specifications

General IconGeneral
Receiver type-
Frequency range10 - 100000 Hz
Pre-out channels1 SW
Input sensitivity200 mV
Pre-out connectivityYes
Audio output channels5.1 channels
Signal-to-Noise Ratio (SNR)98 dB
Total Harmonic Distortion (THD)0.08 %
Power output per channel (1KHz@6 Ohm)145 W
Power output per channel (20-20KHz@8 Ohm)80 W
HDMI in5
Composite video in2
Ethernet LAN (RJ-45) ports1
Multichannel audio output typeRCA
Connectivity technologyWired
AM antenna ports quantity0
Speakers connectivity typeBinding post
Audio formats supportedAAC, FLAC, MP3, WAV, WMA
Image formats supportedJPS
Wi-FiNo
Supported radio bandsFM
Internet radio services supportedvTuner
Product colorBlack
Audio decodersDolby Digital EX, Dolby Pro Logic IIx, Dolby TrueHD, DTS 96/24, DTS-ES, DTS-HD Master Audio
Volume controlRotary
Apple docking compatibilityiPhone
Number of products included1 pc(s)
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.1 W
Power consumption (typical)390 W
Cables includedAC
Weight and Dimensions IconWeight and Dimensions
Depth330 mm
Width434 mm
Height151 mm
Weight8200 g

Related product manuals