HDMI control function
A recent addition to the HDMI standard is CEC (Consumer Electronics Control), which allows control signals from one device to communicate with
another device via the HDMI cable connection. Not all HDMI-equipped devices have this capability.
Setting procedure
1
Set the HDMI output connector corresponding with the
HDMI control function.
Set “HDMI Control” (vpage133) to “On”.
2
Turn the power on for all the devices connected by
HDMI cable.
3
Set the HDMI control function for all devices connected
by HDMI cable.
•Please consult the operating instructions for the connected
devices to check the settings.
•Carry out steps 2 and 3 should any of the devices be unplugged.
4
Switch the television input to the HDMI input connected
to this unit.
5
Switch the input source of this unit to check that video
from the player connected by HDMI is played back
correctly.
6
When you turn the TV’s power to standby, check that
the power of this unit also goes to standby.
NOTE
•Some functions may not operate depending on the connected TV or player. Check
the owner’s manual of each device for details beforehand.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
