Distances
Set distance from listening position to speakers.
Measure beforehand the distance from the listening position to each
speaker.
2 Unit
Set the unit of distance.
Meters (Default)
Feet
2 Step
Set the minimum variable width of the distance.
0.1m (Default) / 0.01m
1ft / 0.1ft
2 Set Defaults
The “Distances” settings are returned to the default settings.
2 Set the distance
0.00m – 18.00m / 0.0ft – 60.0ft
%
•The speakers that can be selected dier depending on the “Amp Assign”
(vpage150) and “Speaker Config.” (vpage151) settings.
•Default settings :
Front L / Front R / F. Height L / F. Height R / Center / Subwoofer : 3.60 m (12.0
ft)
Surround L / Surround R / Surr.Back L / Surr.Back R : 3.00 m (10.0 ft)
•Set the dierence in the distance between the speakers to less than 6.00 m
(20.0 ft).
Levels
Set the volume of the test tone to be the same when it is output from
each speaker.
2 Test Tone Start
Output test tone. A test tone is output from the selected speaker.
While listening to the test tone, adjust the volume output from the
selected speaker.
–12.0dB – +12.0dB (Default : 0.0dB)
%
•When “Levels” is adjusted, the adjusted values are set for all the sound
modes.
•When headphones are connected to the PHONES connector on this unit, you
cannot set “Levels”.
2 Set Defaults
The “Levels” settings are returned to the default settings.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
