Tips
I want the volume not to become too loud by mistake.
•Set the volume upper limit for “Volume Limit” in the menu beforehand. This prevents children or others from increasing the volume too much by
mistake. You can set this for each zone (vpage127, 161).
I want to keep the volume at the same level when I turn the power on.
•By default, the volume setting when power was previously set to standby is applied at next power on. To use a fixed volume level, set the volume level
at power on for “Volume Limit” in the menu. You can set this for each zone (vpage127, 161).
I want to have the subwoofer always output audio.
•Depending on the input signals and sound mode, the subwoofer may not output audio.
When “Subwoofer Mode” in the menu is set to “LFE+Main”, you can have the subwoofer always output audio (vpage155).
I want to make human voices in the movies clearer.
•Use “Dialog Level” in the menu to adjust the level (vpage122).
I want to keep bass and clarity during playback at a lower volume level.
•Set “Dynamic EQ” in the menu to “On”. This setting corrects the frequency characteristics to allow you to enjoy clear sound without the bass being
lost even during playback at a lower volume level (vpage128).
I want to automatically adjust the volume level dierence in content such as TV and movies.
•Set “Dynamic Volume” in the menu. Volume level changes (between quiet scenes and loud scenes) in TV shows or movies are automatically adjusted
to your desired level (vpage129).
I want to set the optimized listening environment after changing the configuration/position of the speakers or
changing a speaker to a new one.
•Perform Audyssey® Setup. This automatically makes the optimized speaker settings for the new listening environment (vpage141).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
