Denon AVR-X2000 - Quick Select Names; Zone Rename

161
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
2 Volume Limit
Make a setting for maximum volume.
60 (–20dB) / 70 (–10dB) / 80 (0dB) (Default : 70 (–10dB))
O : Do not set a maximum volume.
%
•This can be set when “Volume Level” (vpage160) is set to “Variable”.
2 Power On Volume
Define the volume setting that is active when the power is turned on.
Last (Default) : Use the memorized setting from the last session.
Mute : Always mute when power is turned on.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
%
•This can be set when “Volume Level” (vpage160) is set to “Variable”.
2 Mute Level
Set the amount of attenuation when muting is on.
Full (Default) : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
%
•This can be set when “Volume Level” (vpage160) is set to “Variable”.
Zone Rename
Change the display title of each zone to one you prefer.
MAIN ZONE / ZONE2
Set Defaults : The input source name is returned to the default setting.
%
•Up to 10 characters can be input.
•For character input, see page121.
Quick Select Names
Change the “Quick Select” display title to one you prefer.
Quick Select 1 / Quick Select 2 / Quick Select 3 / Quick Select 4
Set Defaults : The input source name is returned to the default setting.
%
•Up to 16 characters can be input.
•For character input, see page121.