Denon AVR-X2000 - Page 195

195
TipsSettingsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Appendix
z1 This item can be selected when a Dolby TrueHD signal is played.
z2 This item can be selected when a Dolby Digital or DTS signal is played.
z3 This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z4 This setting is available when the set sound mode name contains “+PLgz”.
z5 During playback in PURE DIRECT mode, the surround parameters are the same as in DIRECT mode.
z6 This setting is available when “Subwoofer Mode” (vpage155) in the menu is set to “LFE+Main”.
z7 This setting is available when the set sound mode name contains “+PLg Music”.
z8 This setting is possible when the sound mode is “Cinema” mode.
z9 This item cannot be set when “Dynamic EQ” (vpage128) is set to “On”.
z10 This item cannot be set when Audyssey® Setup (Speaker Calibration) has not been performed.
z11 This item cannot be set when “MultEQ® XT” (vpage128) is set to “O” or “Graphic EQ”.
z12 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
z13 In this sound mode, bass is +6 dB, and treble is +4 dB. (Default)