4.
Loading Drive Unit Disassembly I Assembly [Exploded View (3)]
• GEN 2420 Tray Drive (Left) Unit
Gear
(B) and Pulley Gear
@Gear
(
B)
@Pulley
Gear
Tweezers
Slit
·
~
'
To
remove parts other then above, reverse the steps shown below.
Insert
tweezers to the Slit of Gear (B) ® and
Pulley
Gear
@ , loosen the Shaft Coupler,
Pull
Gear
(B) and Pulley Gear upward.
Shaft Coupler
7lf Assembly of the loading unit is critical, and unless the work is done properly con invite malfunction.
• GEN 2420 Tray drive (Left) unit
@ Gear(B)
@
Cam
Stopper
@ Switch
P.W
.B.
Assembly Step
i.
Insert the Switch Shafts @ to the 4 holes of Drive Base Ass'y
G)
from bottom side, hook Switch P.W.B . @ , and then insert
Loading Motor Sub-Ass'y to arrow direction and hook
it.
(The work is reversal of Drive Base Ass
'y
G)
)
23
To Next Page
