16
If 10 call numbers are already stored and a new number is
added to the list, the oldest number is deleted from the list.
Note : Call numbers comprising less than 4 digits (e.g.
internal numbers when a PBX is used) are not stored in
this list.
An incoming call is indicated on the handset and the base
station by the ringer (pp. 24 and 25) and also by the B
symbol flashing on the handset display.
To accept the call, press g.
If you are in the middle of a conversation when an incoming
call is indicated or do not wish to be disturbed by the ringer
for other reasons, press s. This mutes the ringer on your
handset (for this call only). The caller will continue to hear
the ringing tone and you can accept the call by pressing
g, as long as the caller hasn't hung up.
In the case of an internal call, pressing s twice rejects the
call. The caller then hears the busy signal.
You can store up to 10 frequently used call numbers in the
speed-dialling memory. These numbers occupy memory
slots 0…9.
The telephone is ready for use.
Start save function:
Press P (w).
Press the signal key R.
Press P (w) once again.
The content of the first memory
slot is now shown on the display (01).
Selecting a different memory slot:
Press P (w) repeatedly
(the next memory slot, respectively, is displayed)
or
Press the desired numerical key 0…9.
Confirm selection:
Press o.
Enter Call number:
A BCD E FGHI
=!–
Accepting a
call
Ringer mute
Speed dialling
Storing/Over-
writing call
numbers
To Next Page
Loading...