DETEWE BeeTel - Setting the Total Recording Time; Incoming Call Monitoring; Adjusting the Volume

34
- Enter the following key sequence: o#3.
- The current setting is displayed.
010 = 10 seconds
960 = 960 seconds
- Enter the desired message duration as a three-digit number.
- Press o.
- Terminate the connection by pressing g.
You can set the recording capacity of your answering
machine to either 8 or 16 minutes. The higher capacity is
achieved through data compression, which results in a
slight impairment of the speech quality. This setting can be
changed at any time, and has no effect on existing messa-
ges.
- Enter the following key sequence:o#2.
- The current status is displayed.
1 = 16 minutes (Hi)
2 = 8 minutes (Lo)
- Enter the desired number.
- Terminate the connection by pressing g.
If the "Monitoring" function is activated, you can follow mes-
sages being recorded via the base station speaker. In this
context, you also have the option of intercepting the call via
a handset (g-key) and speaking directly with the caller.
- Enter the following key sequence: o#.
- Enter the numerical code 00
0 = Monitoring off
1 = Monitoring on
- Enter the desired number.
- Terminate the connection by pressing g.
The base station volume can be adjusted in 6 increments
and applies both to the playback of recorded messages and
the monitoring of incoming messages.
- Enter the following key sequence: o#.
- Enter the numerical code 01
1 … 6 = Volume (1 = quiet / 6 = loud)
ABC D E FGHI
å∂ ! ª⁄
ABC D E FGHI
å∂ ®™ç !(= ‚™ç
Setting the
total recording
time
Incoming call
monitoring
Adjusting the
volume