Micronics C400 System Board Manual
Chapter 1: Quick Installation
9
1
Chapter
Quick Installation
We know that many experienced people prefer to read as
little of the documentation as possible. If this sounds like
you, here’s the short form to get up and running quickly.
Installing the Micronics C400
1. Make backup copies of your installation and configu-
ration diskettes.
2. Ground yourself to prevent damaging static dis-
charge by using an anti-static wrist or ankle strap, or
touch a safely grounded metal object.
3. Remove the Micronics C400 from its packaging.
4. Configure and verify the system board’s jumper set-
tings (refer to Jumper Settings in Chapter 2).
5. Install the CPU and the system memory. Be sure to
attach the Retention Mechanism as described in
Chapter 3.
6. Install the system board in the chassis and make all
necessary case connections.
7. Install any ISA, PCI and/or AGP add-on peripherals
(refer to Chapter 2 for the location of the slots).
8. Connect any optional devices.
9. Turn the computer on and press the <DEL> key
when you see the screen shown in Figure 1.1.
STATIC!
Before
handling the
Micronics
C400, be
properly
grounded
by using a
special wrist
or ankle
strap, or
touch a
safely
grounded
object.
To Next Page
Loading...
Need help?
General