Micronics C400 System Board Manual
53
Supervisor Password
The Supervisor Password utility allows you to setup, change
or disable the password stored in the BIOS. The Supervisor
Password allows access to the system Setup. To setup or
change a password, highlight the SUPERVISOR PASS-
WORD option on the main menu screen and press <EN-
TER>.
The password can be no more than eight characters long.
The program will prompt you to confirm the new password
before exiting and enabling the utility. To disable the
password, press <ENTER> when the program prompts
you to enter the new password.
WARNING: If you forget the Supervisor Password, it cannot be
disabled without resetting the CMOS.
User Password
The User Password utility allows you to setup, change or
disable the password stored in the BIOS. Follow the same
procedure used to setup the Supervisor Password. The
User Password allows power-on access to the system, but
will not allow you to modify the CMOS settings.
NOTE: The User Password can only be set after setting the
Supervisor password.
Chapter 4: The BIOS Setup Utility
To Next Page
Loading...
Need help?
General