Micronics C400 System Board Manual
Chapter 4: The BIOS Setup Utility
PnP/PCI Configuration Setup
The PnP/PCI Configuration Setup option sets the various
system functions and internal addresses of PnP and PCI
devices and onboard PCI IDE controller. To access the
PnP/PCI CONFIGURATION SETUP screen, highlight
this option on the main menu screen and press <EN-
TER>.
Figure 4-7: PnP/PCI Configuration Screen
PnP OS Installed
When set to Yes, this selection allows the system to work
with a Plug and Play (PnP) operating system such as
Windows 95. The PnP BIOS will configure only PCI and
ISA Plug and Play cards needed to boot the system, and
allow the operating system or device drivers to configure
the remaining cards. The default setting is No.
Resources Controlled By
The Micronics C400’s Plug and Play BIOS can automati-
cally configure all the boot and Plug and Play-compatible
47
To Next Page
Loading...
Need help?
General