Micronics C400 System Board Manual
54
IDE HDD Auto Detection
The IDE HDD Auto Detection option provides auto
configuration of the hard drive installed in your system. To
access the IDE HDD Auto Detection screen, highlight
this option on the main menu screen and press <EN-
TER>.
Figure 4-9: IDE HDD Auto Detection Screen
The IDE HDD Auto Detection option provides auto
configuration of the hard drive installed in your system. It
supports LBA, Large and Normal modes.
If your hard disk drive’s capacity is under 528MB, select
Normal mode. NOTE: It is recommended that you select
Normal mode for your hard disk drive if you will be using
UNIX. If the system’s hard disk drive has a capacity of over
528MB and supports LBA functions, you may enable either
the LBA mode or the Large Mode.
Chapter 4: The BIOS Setup Utility
To Next Page
Loading...