Micronics C400 System Board Manual
Used Memory Base Address
Select a base address for the memory area used by any
peripheral that requires high memory.
Used Memory Length
Select a length of memory area specified by any peripheral
that requires high memory. NOTE: This option is available
only if Used Memory Base Address is not set at N/A.
Load BIOS Defaults
This selection loads the BIOS default values that would
allow safe booting of the system in the event of a BIOS
configuration memory loss. To select LOAD BIOS
DEFAULTS, highlight this option on the main menu screen
and press <ENTER>. Press <Y> or <N> when the
program prompts you with the Load BIOS Defaults ques-
tion.
Load Setup Defaults
This selection allows automatic configuration of all the
options in the Standard CMOS Setup, BIOS Features
Setup and Chipset Features Setup with the setup defaults.
If problems are encountered after loading the setup de-
faults, reboot the system and load the BIOS defaults. To
select LOAD SETUP DEFAULTS, highlight this option on
the main menu screen and press <ENTER>. Press <Y>
or <N> when the program prompts you with the Load
Setup Defaults question.
Chapter 4: The BIOS Setup Utility
49
To Next Page
Loading...
Need help?
General