Micronics C400 System Board Manual
Installing an ISA Peripheral Card
The Micronics C400 ISA slots accommodate all standard
ISA peripherals. Follow the steps below to install an ISA
card:
1. Turn the computer system off and remove its cover.
2. Choose an unused ISA slot and remove the slot cover.
3. Insert the card with the bottom edge level to the slot.
Never insert the card at an angle.
4. Carefully push the card straight down, making sure
the card is fully inserted.
5. Replace the screw that holds the card in place.
6. Replace the computer cover.
7. Refer to the ISA card’s documentation for addi-
tional instructions regarding installation and soft-
ware drivers.
Chapter 3: Installing the Micronics C400
29
Figure 3-5: Installing an ISA Peripheral Card
To Next Page
Loading...