Diamond Multimedia Micronics C400 - Figure 4.1: Power-Up Screen

Micronics C400 System Board Manual
32
When the system is turned on, it performs a memory test,
and a BIOS identification and system information screen
is displayed on your monitor, as shown in Figure 4-1.
Figure 4-1: Power-Up Screen
When “Press DEL to enter Setup” appears at the bottom
of the screen, press the <DEL> key to start the Setup
program. The main CMOS Setup utility screen (Figure
4-2) appears. Note that the Setup program can only be
activated during the boot sequence.
Chapter 4: The BIOS Setup Utility