Micronics C400 System Board Manual
Appendix E: Warranties and Notices
77
FCC Statement
This equipment has been tested and found to comply within
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses and can radi-
ate radio frequency energy and, if not used in accordance
with the instructions, may cause harmful interference to
radio communications. Interference to radio or television
reception can be determined by turning the equipment off
and on. You are encouraged to try to correct the interfer-
ence by one or more of the following measures:
▲ Reorient the receiving antenna.
▲ Increase the separation between the equipment and
the receiver.
▲ Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
▲ Consult your dealer or an experienced radio/TV
technician for help.
To meet FCC requirements, shielded cables are required.
NOTE: Changes or modifications not expressly approved by
Diamond could void your authority to operate the equipment.
To Next Page
Loading...
Need help?
General