Micronics C400 System Board Manual
Chapter 4: The BIOS Setup Utility
37
Quick Power-On Self-Test
When enabled, this selection will reduce the amount of
time required to run the Power-On Self-Test (POST). A
quick POST skips certain steps. We recommend that you
disable quick POST. The default setting is Enabled.
Boot Sequence
Boot Sequence selects the order in which the system
searches for a boot disk. The default setting is C, A, SCSI.
Swap Floppy Drive
This selection can be set to remap the floppy drives. When
set to Enabled, drive A: becomes drive B: and drive B:
becomes drive A:.
Boot Up Floppy Seek
When set to Enabled (default), the BIOS tests (seeks)
floppy drives to determine whether they have 40 or 80
tracks. Drives with 720KB, 1.2MB and 1.44MB capacity
all have 80 tracks.
Boot Up Numlock Status
Toggle between On and Off to control the state of the
NumLock key when the system boots. When toggled On,
the numeric keypad generates numbers instead of con-
trolling cursor operations. The default setting is On.
Boot Up System Speed
Select the system boot up speed. The default setting is
High.
To Next Page
Loading...