Digi XBee

AT commands Network commands
XBee/XBee-PRO® S2C ZigBee® RF Module
225
Parameter range
1 - 0x3F
Default
3
Network commands
CH (Operating Channel)
Read the channel number used to transmit and receive data between RF devices and uses 802.15.4
channel numbers.
A value of 0 means the device has not joined a PAN and is not operating on any channel.
Parameter range
0, 0x0B - 0x1A (XBee)
0, 0x0B - 0x19 (XBee-PRO, Channels 11-25)
Default
[read-only]
CE (Coordinator Enable)
Sets or reads whether the device is a coordinator.
Parameter range
Parameter Description
0 Not a Coordinator
1
Coordinator
(SM must be 0 to set CE to 1)
Default
0
ID (Extended PAN ID)
Set or read the 64-bit extended PAN ID. If set to 0, the coordinator selects a random extended PAN ID,
and the router/end device joins any extended PAN ID.
Write changes to ID to non-volatile memory using the WR command to preserve the ID setting if a
power cycle occurs.
Parameter range
0 - 0xFFFFFFFFFFFFFFFF
Default
0