Regulatory information Europe (CE)
XBee/XBee-PRO® S2C ZigBee® RF Module
285
n Maximum power: 9.91 mW (9.96 dBm) EIRP.
n Frequencies: 5 MHz channel spacing, beginning at 2405 MHz and ending at 2480 MHz.
OEM labeling requirements
The “CE” marking must be affixed to a visible location on the OEM product. The following figure shows
CE labeling requirements.
The CE mark shall consist of the initials “CE” taking the following form:
n If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
n The CE marking must have a height of at least 5 mm except where this is not possible on
account of the nature of the apparatus.
n The CE marking must be affixed visibly, legibly, and indelibly.
Important note
Digi customers assume full responsibility for learning and meeting the required guidelines for each
country in their distribution market. Refer to the radio regulatory agency in the desired countries of
operation for more information.
Declarations of conformity
Digi has issued Declarations of Conformity for the XBee RF Modules concerning emissions, EMC, and
safety. For more information, see www.digi.com/resources/certifications.
Antennas
The following antennas have been tested and approved for use with the XBee/XBee-PRO ZigBee RF
Module:
All antenna part numbers followed by an asterisk (*) are not available from Digi. Consult with an
antenna manufacturer for an equivalent option.
To Next Page
Loading...
Need help?
General
