Digital Dream DDCS V3.1 User Manual

Digital Dream Standalone Motion Controller DDCS V3.1 DDCS V3.1 Users Manual
Page -35
Figure 3-21 Program will run from the chosen line
3.3.2.4 Pause in operation
During file processing, press the key to pause the operation. The Operation Status
Column will display “READY” and the Z axis will lift the tool to the defined safe height.
PAUSE
3.3.2.5 ESTOP in operation
During file processing, press the key to ESTOP the procedure. The Operation Status
Column will display “RESET” flashing. The spindle will stop.
RESET
3.3.2.6 Start/Stop spindle
Only when the Operation Status Column displays “READY” you can manually start or stop the
spindle. Use the spindle button to switch from Start to Stop and back.
SPINDLE
3.3.3 Manually position the machine
You can manually position the machine at any position. You can move Continuously, in
defined Steps or with the MPG. The button moves you through the three options:
Mode

Digital Dream DDCS V3.1 Specifications

General

Brand	Digital Dream
Model	DDCS V3.1
Category	Controller
Language	English