Digital Dream DDCS V3.1 - Page 60

Digital Dream Standalone Motion Controller DDCS V3.1 DDCS V3.1 Users Manual
Page -59
Figure 3-69 Firmware Version No.
According to the customer feedback, we will endeavour to update the software in DDCS V3.1 , to
enhance the performance, fix the bugs or add new features. In order for customer to download
the latest firmware, please visit our website :
www.ddcnc.com
or our Facebook Forum:
https://www.facebook.com/groups/1724999967517167/?ref=group_header or join our forum
http://bbs.ddcnc.com/forum.php
There you can find the latest version firmware for DDCS . At the Left-bottom side of the Main
Page,there is the firmware version as the Figure 3-69:
3.4 Software Update
3.3.5.5 Trial Cutting Funciton
The ToolPath Key ccan also be re-defined as a“TryCutting” function key as defined by
Parameter #3, it must be controlled with a connected MPG,this funciton also can be called as
“handwheel guide”.
When the system is READY,press it then Start the file,the controller turns into Try Cutting
Status,you can use the MPG to operate;When system is AUTO,users press it the controller also
turns to Try Cutting status.Press the key again,system exit from Try Cutting.
TOOL PATH
Figure 3-68 Try Cutting