INSIGHT 4K LASER User Manual
Compliance with international standards
RF Interference
FCC
The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by Digital
Projection in this manual. Failure to comply with this government regulation could void your right to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant with Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area may cause harmful interference, in which case the user will be responsible for correcting any
interference.
Machine Noise Information Regulation
The highest sound pressure level is less than 70 dB (A) in accordance with EN ISO 7779.
European Waste Electrical and Electronic Equipment (WEEE) Directive
Digital Projection Ltd is fully committed to minimising Waste Electrical and Electronic Equipment. Our products are designed with
reuse, recycling and recovery of all components in mind. To this end, at end of life, your projector may be returned to Digital Projection
Ltd or its agent so that the environmental impact can be minimised.
DOC compliance notice
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Page 11 of 65
To Next Page
Loading...
Need help?
General
