Digital Projection Insight Laser 4K - IP Address; Setup Date; Option Status

INSIGHT 4K LASER User Manual
Displays the laser light source firmware version of the projector.
← Displays the version information.
4.6.7. IP Address
Displays the IP address set in the projector.
← Displays the IP address.
4.6.8. Setup Date
Displays the date when the projector was set up (starting date of the warranty period).
← Displays the date when the projector was set up (starting date of the warranty period).
4.6.9. Option Status
Displays the link status of the device mounted in slot A (media block, signal input board) on the projector. The device name is displayed in ( )
when the projector is in standby or when connection to the device cannot be confirmed.
← Slot B is not available in this projector.
← Displays the link status of the device in slot A.
B Not Available: Slot B is not available in this projector.
A
Displays the link status of the device in slot A.
<Vendor Name> IMB: Media block (NP-90MS01)
• NC-80LB: Signal input board (NC-80LB01-B)
• NC-80DS: Signal input board (NC-80DS01-B)
• No Board: No device mounted
System Displays the IP address set for the projector (System).
Laser
Page 45 of 65