INSIGHT 4K LASER User Manual
3.7. Turning your projector off
1) Press the POWER button on the projector control panel for three seconds or longer.
The light source is turned off, the POWER button indicator blinks green, and the SYSTEM status indicator blinks orange
(cooling state). The
fan will continue to rotate while cooling, and the amount of time remaining for cooling is displayed on the LCD screen.
When the cooling is finished, the POWER button indicator turns off and the SYSTEM status indicator lights orange (standby state).
KEY LOCK becomes automatically on if no control panel operation takes place in the standby state for 30 seconds by default. Buttons
on the control panel do not function while KEY LOCK is on. (See page 32)
2) Wait till the projector enters standby state before turning off the main power switch of the projector.
The POWER button indicator is turned off and the main power is turned off.
3)
Turn off the AC power to the projector.
In the following instances, do not turn off the main power switch or disconnect the AC power. Doing so can damage the projector.
• While projecting images
• While the power is on
• During the cooling after the light source is turned off. The cooling time varies depending on the option board you are using.
o When using the NP-90MS01: 90 seconds
o When using a board other than the NP-90MS01: 10 seconds
• During IMB operation (if the projector is not in standby state)
Page 32 of 65
To Next Page
Loading...
Need help?
General
