Important safeguards
These safety instructions are to ensure the long life of your projector and to prevent fire, shock, damage and injury. Please read them carefully
and heed all warnings.
Laser precautions
This product is classified as Class 3R of IEC60825-1 and 21 CFR Part 1040.10 Safety Standards.
CLASS 3R LASER PRODUCT
This Laser Product is designated as Class 3R during all procedures of operation. LASER LIGHT - AVOID DIRECT EYE
EXPOSURE.
Do not point laser or allow laser light to be directed or reflected toward other people or reflective objects.
Direct or scattered light can be hazardous to eyes and skin.
There is a potential hazard of eye exposure to laser radiation if the included instructions are not followed.
Caution – use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
Class 2 range. Class 3R laser product, per IEC 60825-1, has limited risk of laser hazard and is safe for non-intrabeam
viewing. It is recommended to keep the audience 100 cm away from the exit plane of the lens hood and reduce the laser
hazard to a much safer class 2.
Non-laser emission. There remains non-laser emission from the projection lens. This portion of emission has been
tested per IEC/EN 62471 to be Risk Group 1 (Low Risk).
General precautions
This is a Class A product. It has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
In order to reduce any interference with radio and television reception, use a signal cable with ferrite core attached. Use
of signal cables without a ferrite core attached may cause interference with radio and television reception.
The unit is never to be operated if the unit is defective or the cover or seal is damaged.
The end user is not allowed to open or modify the product. No maintenance allowed by end user.
Do not open the cabinet. There are no user serviceable parts inside.
No service is allowed except by authorized personnel.
Page 6 of 65
To Next Page
Loading...
Need help?
General
