INSIGHT 4K LASER User Manual
4.4.3. Reset
This is used to reset the air filter usage time.
Resets the air filter usage time. Press the ENTER button, then select “Yes” in the displayed confirmation screen, and then press
the ENTER
button to reset the air filter usage time.
← Press the ENTER button to display the confirmation screen.
4.4.4. Installation
Sets the type of lens (supports or does not support the lens memory function) attached to the projector. This menu item is
available only
when you are logged into the projector with Advanced User or higher privileges.
← Displays the currently selected item with asterisk (*).
← Displays the setting.
Without Sensor Selected when using a lens unit that does not support the lens memory function (default value).
Selected when using a lens unit that supports the lens memory function.
Performs calibration on lenses that support the lens memory function. Once you have attached a lens that supports the lens
memory
function, always execute calibration. This menu item is available only when the projector power is turned on and you
are logged into the
projector with Advanced User or higher privileges.
This items cannot be used if Lens Type is set to “Without Sensor”.
← Press the ENTER button to execute calibration.
To move the lens shift to the center position. The center position may slightly shift depending upon mounting conditions of the
lens. This menu
item is available only when the projector power is turned on and you are logged into the projector with
Advanced User or higher
privileges.
← Press the ENTER button to execute moving.
To Next Page
Loading...
