INSIGHT 4K LASER User Manual
When the startup of the projector completes, the status of the POWER button, DOUSER button, LIGHT ON/OFF button, and preset button
(button <1> to <8>) changes as follows.
POWER button
Lit green
DOUSER button
Initial settings: Off (douser is off)
LIGHT ON/OFF button
Initial settings: Blinking green (light source is off)
Button <1> to <8>
The preset button which was last selected is lit green
4) Press the LIGHT ON/OFF button on the control panel for five seconds or longer.
The light source is turned on and the screen glows light about 15 seconds later.
The douser is closed until the screen glows light (the DOUSER button indicator lights green). When the douser is open, the DOUSER
button indicator turns off.
While your projector is on, be sure to have the lens cap and glass protector cap removed from the lens. Otherwise, the lens cap or
glass protector cap may get deformed due to a heat buildup.
In the following instances, the power to your projector cannot be turned on even if you press the POWER
button:
• When the inside temperature is abnormally high. The protective function prevents power from turning on. Wait some time
(until the projector inside cools down) and then turn on the power.
• When the SYSTEM status indicator is blinking in red without the light source lighting up after power-on. Your projector may
be in trouble. Check the error display on the LCD screen and contact your dealer/distributor for instructions.
Page 25 of 65
To Next Page
Loading...
Need help?
General
