E-16
English
6.1
Sets the desired hot water temperature 30 °C
... 45 °C ...
85 °C
Domestic hot water
Sensor
Sets the time programs for hot water blocks Domestic hot water
Sets the times in which DHW preparation is
blocked
00:00
...
23:59
Domestic hot water
For each day of the week, it is possible to select
whether Time1, Time2, no time or both times
are to be active when the temperature is
lowered. Operations to lower the temperature
that exceed a week day are activated or
deactivated at the end of each day accordingly.
N
T1
T2
Y
Heating circuit 3
To carry out a thermal disinfection, the DHW is
heated up once to the desired temperature.
The heating period is terminated automatically
when the set temperature is reached or after 4
hours at the latest.
Domestic hot water
Sensor
Bivalent or flange
heater
Sets the start time for the thermal disinfection 00:00
...
23:59
Domestic hot water
Sensor
Bivalent or flange
heater
Sets the desired hot water temperature which is
to be reached during thermal disinfection
60 °C
... 65 °C ...
85 °C
Domestic hot water
Sensor
Bivalent or flange
heater
For each day of the week, it is possible to select
whether thermal disinfection is desired at the
set start time.
N
Y
Domestic hot water
Sensor
Bivalent or flange
heater
By setting Reset to “Yes”, the maximum
calculated hot water temperatures in HP
operation are reset to a value of 65 °C. The
setting is automatically reset to “No”.
No
Yes
Domestic hot water
Sensor
Sets the preparation of swimming pool water Swimming pool
Sets whether swimming pool water preparation
is carried out with 1 or 2 compressors
1 Compressor
2 Compressors
Swimming pool
2 Compressors
Nonreversible HP
Sets the time programs for blocking swimming
pool water preparation
Swimming pool
Sets the time in which a swimming pool block is
to take place
00:00
...
23:59
Swimming pool
For each day of the week, it is possible to select
whether Time1, Time2, no time or both times
are to be active for a swimming pool block.
Blocks that exceed a week day are activated or
deactivated at the end of each day accordingly.
N
T1
T2
Y
Swimming pool
The output of the auxiliary circulating pump can
be configured to allow parallel operation of the
auxiliary circulating pump and the heat pump's
compressor. Configuration is possible for
heating, DHW preparation and swimming pool
water preparation. The antifreeze functions are
ensured.
At all times
System-specific parameters
Setting range Display
To Next Page
Loading...
Need help?
General
