Operating Instructions RF-2000
71
8.2.3 Operating time of xenon lamp
Operating time of the xenon lamp is displayed in XE TIME in AUX. FUNC. The value
is automatically accumulated while the lamp is lit on. Enter 0 and Enter to reset the
time when replacing the lamp. Operating time of lamp is indicated in the unit of hour.
Please note:
Reset the time only when replacing the lamp.
8.2.4 Replacing procedure for xenon lamp
Replace the xenon lamp following the same procedure as described in section "4.6
Installing the Xenon Lamp" and "4.7 Adjusting the Xenon Lamp Alignment".
Important:
Xenon lamp is extremely hot right after turning the power
switch OFF. Wait for more than an hour after turning the power
switch OFF and be certain that the xenon lamp is no longer hot
by opening the light source chamber cover before replacement.
When LAMP of AUX FUNC is set to "0", xenon lamp is turned off with the power still
supplied. (Refer to "5.5.1 AUX FUNC.") The lamp is cooled down in about 30 min.
under this condition. After cooling down of the lamp, turn the power switch OFF, pull
out the power cable and wait for 5 min before replacing the lamp.
To Next Page
Loading...
