Operating Instructions RF-2000
6
1.4 Precautions on Installation Site and Handling of the Unit
Generally, a large amount of organic solvents is used in the high-performance liquid
chromatograph. Sufficient care should be taken in installation site and handling of the
unit. Please take care of the notices in the text, not to mention the precautionary
requirements listed below:
1.4.1 Ventilation
Solvents used in the high-performance liquid chromatograph are inflammable
and/or toxic. Be sure to ventilate the room well.
1.4.2 Fire
The lighting of fires is prohibited in the room where high-performance liquid
chromatograph is installed. Do not install any devices which may emit sparks
in the room. It is also necessary to provide a fire extinguisher preparing for the
worst.
1.4.3 Safety goggles
Wear safety goggles in handling solvents.
1.4.4 Other equipment
A washstand or the like is necessary to be furnished nearby preparing for the
cases such that solvent comes into the personnel's eyes or the personnel
touches toxic solvent.
1.4.5 Power source
Working voltage range and power consumption of this system are as follows.
Be sure to connect to the power source conforming to them.
Part No. 706.228.35353.38, 220-230V ~ ±10%/240V ~ ±10%, 350VA,
50-60Hz
If working with a different working range, different fuses must be used! Please
contact the Dionex Service.
1.4.6 Grounding
To prevent electric shock and to secure safe operation of the system, always
make grounding.
1.4.7 Repair and maintenance of the unit
Normal maintenance of this unit can be performed without removing the
cover. Do not remove the cover at the normal maintenance. Contact the
Dionex Service if repair requires to remove the cover of the main body.
To Next Page
Loading...
