Directed 5305 - Reset and Deletion

24
© 2015 Directed. All rights reserved.
Reset and Deletion
If a feature or Virtual Tach needs to be reset or the remote controls need to be deleted, use the following
procedure.
1. Open a door. (The 24-pin harness Green wire or the Violet wire must be connected).
2. Turn the ignition to the ON position (The heavy gauge Pink wire must be connected).
3. Within 10 seconds, press and release the Control Center button: two times if you want to delete remote
controls, three times to reset features or four times to reset virtual tach. These function steps are described
next.
Step 2:
Delete remotes: This feature erases all remote controls from the memory of the security system. This is
useful in cases when a customer’s remote is lost or stolen.
Note: This does not reset the programmed features of the security system or reset the Virtual Tach
setting.
Step 3:
Reset Features: This resets features all of the security system to the factory default settings.
Note: This feature does not delete the remote controls from the security system or reset the Virtual
Tach setting
Step 4:
Virtual Tach Reset: Deletes all previously learned values for Virtual Tach, and on the next remote start
sequence the unit begins Virtual Tach initialization.
Note: The “Zap” feature on the Bitwriter does not reset the Virtual tach setting.
4. Once you have selected the function step, press the Control Center button once more and hold it. The
LED flashes and the siren chirps to confirm the selected functional step. Do not release the Control Center
button.
5. While still holding the Control Center button, press the
AUX
button on the remote control. The unit chirps to
confirm that the feature has been successfully reset.
6. Release the Control Center button and turn the key Off.
7. The siren will emit one long chirp confirming that the Reset and Delete mode has been exited.
The Reset and Delete mode exits if any of the following occurs:
• The open door is closed.
• The ignition is turned off.
• There is no activity for 30 seconds.
• The Control Center button is pressed too many times.