Menu 2 - Advanced
Menu
Item
One-chirp setting Two-chirp and up setting
1
Siren Duration: 30 second
60 second*
2
NPC (Nuisance Prevention Circuitry): On
OFF
3
Progressive Door Trigger: On
Off
4
Valet Switch Pulse Count: 1
2-5 pulses
5
Door Trigger Error Chirp: On
OFF
6
Ignition Controlled Domelight: On
OFF
7
Unlock Output: 1 pulse
2 pulses
8
Lock Output: 1 pulse
2 pulses
9
OEM Alarm Disarm With Trunk Release: On
OFF
10
OEM Alarm Disarm Output with Unlock
Before Unlock (2), Remote Start Only (3)
11
OEM Alarm Disarm Pulses: 1 pulse
2 pulses
12
AUX 4 Output Type: Validity **
Latched (2), Latch reset with ignition
(3), 30-sec timed (4), 60-sec (5), 90-sec (6)*
13
AUX 4 Linking: None
Arm (2), Disarm (3), Remote Start (4)
14
AUX 5 Output Type: Validity **
Latched (2), Latch reset with ignition (3),
30-sec. timed (4), 60-sec (5), 90-sec (6)*
15
AUX 5 Linking: None
Arm (2), Disarm (3), Remote Start (4)
16
AUX 6 Output Type: Validity **
Latched (2), Latch reset with ignition (3), 30-sec. timed (4)
60-sec (5), 90-sec (6)*
17
AUX 6 Linking: None
Arm (2), Disarm (3), Remote Start (4)
* Additional settings using the Bitwiter.
** On the Bitwriter AUX 4 is labeled as “AUX 2”, AUX 5 as “AUX 3”, and AUX 6 as “AUX 4”.
Menu 2 - Descriptions
1. Siren Duration (Brown wire on 5-pin harness):
1. 30 sec.: The siren output for full trigger activations and Panic mode is 30 seconds.
2. 60 sec.: The siren output for full trigger activations and Panic mode is 60 seconds.
2.- NPC (Nuisance Prevention Circuitry):
1. On: Sensors that trigger excessively will be defeated until they have been stable for more than one hour.
2. Off: Sensors will not be defeated if triggered excessively.
3. Progressive Door Trigger (Green or Violet wire on 24-pin harness):
1. On: When the door is opened with the system armed, the siren will chirp 10 times prior to the full trig-
gered sequence.
2. Off: The full siren output will occur the moment the door is opened.
4. Valet/Override Switch Pulse Count:
• 1-5: Sets the number of presses (1-5) on the Control Center Button required to override the alarm system.
5. Door Trigger Error Chirp:
1. On: If the door trigger is active when arming, the siren will emit an additional chirp as an alert.
2. Off: An active door trigger when arming will not create an alert output.
6. Ign-controlled Domelight:
1. On: The system will turn on the dome light for 30 seconds when the ignition is turned off.
2. Off: The system does not turn on the domelight when the ignition is turned off.
Note: The domelight supervision option must be installed.