Directed 5305 - Bitwriter Options and Reset Procedures; Bitwriter Only Options

Bitwriter - Only Options
If programming with the Bitwriter, the Learn Routine can be locked or unlocked. If the Learn Routine
has previously been locked, it must be unlocked with Bitwriter - this cannot be done manually with the
Control Center button.
The Bitwriter gives you access to a wider range of system options. These features and the adjustments
that may be programmed are described in the table below.
Menu
Item
Feature Default Options
1 Siren Duration (in seconds)
30 sec.
1-180 sec.
2 AUX 4 Timed Output (in seconds)*
30 sec.
1-90 sec.
3 AUX 5 Timed Output (in seconds)*
30 sec.
1-90 sec.
4 AUX 6 Timed Output (in seconds)*
30 sec.
1-90 sec.
5 Engine Runtime (in minutes)
12 min.
1-60 min.
6 Diesel Start Delay (in seconds)
15 sec.
1-90 sec.
7 Timer Mode Runtime (in minutes)
12 min.
1-16 min.
8 Virtual Tach Fine Tune (in milliseconds)
Not initialized
0-1000 in 50 ms increments
9 Transmitter Programming
Unlocked
Locked
10 Feature Programming
Unlocked
Locked
* On the Bitwriter AUX 4 is labeled as “AUX 2”, AUX 5 as “AUX 3”, and AUX 6 as “AUX 4”.
Note: The “Zap” feature on the Bitwriter does not reset the Virtual Tach or Security Features Enabled/Disabled
settings.
Bitwriter Feature Descriptions
1. Siren Duration:
Sets the siren output for full trigger activations from 1-180 seconds.
2. AUX 4 Timed Output:
Sets the output duration in 1 second intervals up to 90 seconds.
3. AUX 5 Timed Output:
Sets the output duration in 1 second intervals up to 90 seconds.
4. AUX 6 Timed Output:
Sets the output duration in 1 second intervals up to 90 seconds.
5. Engine Runtime:
Sets engine runtime during normal remote start operations from 1-60 minutes.
6. Diesel Start Delay:
Sets the WTS delay before engine crank in 1 second intervals from 1- 90 seconds for diesel engine vehicles.
7. Timer Mode Runtime:
Sets the duration of runtime when the engine is started by the Timer Mode from 1-16 minutes.
8. Virtual Tach Fine Tune:
Adds or subtracts starter crank time in Virtual Tach mode in order to overcome engine types that short crank
or over-crank on the first start attempt.
9. Transmitter Programming:
Locks and unlocks the user’s ability to enter the Remote Control Pairing/Reset menu and manually change any
functions using the Control Center button.
10. Feature Programming:
Locks and unlocks the user’s ability to enter the Feature Menus and manually change the main unit program-
ming using the Control Center.