2 Setting Up the Meter AIM User’s Manual
29
3 Use c or d to highlight the automatic timer setting you want to change:
– Highlight Backlight Timer to set the time limit for automatically turning off
the display backlight after no buttons have been pressed.
– Highlight Standby Timer to set the time limit for automatically entering
Standby mode after no buttons have been pressed.
– Highlight Shutdown Timer to set the timer for automatically turning off the
meter after no buttons have been pressed.
4 Use the numeric keypad to enter a timer setting.
5 Press NEXT to return to the SETTINGS screen.
Tip: Press HOURS, MINUTES, or SECONDS to
switch between time units. To turn off the timer,
enter “0”.
Note: To delete a character, press the Back
button. You also can use e or f to navigate
within your entry, or press CLEAR to delete the
entry and start over. Press CANCEL to exit
without saving changes.
To Next Page
Loading...