3 Setting Up a Job AIM User’s Manual
36
Zip Code
To change the zip code for a job:
1 On the MODIFY JOB SETUP screen, use c or d to highlight Zip Code and
press SELECT to go to the ZIP CODE screen.
2 Using the numeric keypad, enter the zip code for the job. Then press ENTER.
The default azimuth, elevation and tilt coordinates for the job appear.
3 Press DONE to return to the MODIFY JOB SETUP screen.
Tip: To delete a character, press the Back
button. You also can use e or f to navigate
within your entry, or press CLEAR to delete the
entry and start over. To exit without saving
changes, press CANCEL.
To Next Page
Loading...