2 Setting Up the Meter AIM User’s Manual
28
Changing Automatic Timer Settings
You can change the automatic timer settings for your AIM, including:
Backlight Timer: If no buttons have been pressed on the AIM after the
specified time limit, the backlight on the display turns off. The backlight
automatically turns back on when you press any button on the meter.
Standby Timer: If no buttons on the AIM have been pressed after the specified
time limit, the meter automatically enters a power-saving mode called Standby.
The AIM automatically exits Standby mode when you press and hold the
POWER button until the backlight turns on.
Shutdown Timer: If no buttons on the AIM have been pressed after the
specified time limit, the meter automatically turns off. The meter can be turned
back on by pressing and holding the POWER button until the backlight turns on.
The AIM’s automatic timer settings are designed to help extend the battery charge.
You can customize the automatic timer settings. However, extending the time
period longer than the default setting decreases the time that the battery charge
lasts.
To change automatic timer settings:
1 Press CONFIG to go to the CONFIGURATION screen.
2 Use
c or d to highlight Settings and press SELECT to go to the SETTINGS
screen, which shows the current settings for the meter.
To Next Page
Loading...
Need help?
General
