6 Performing Other Network Tests AIM User’s Manual
56
11 On the SAT TUNE RESULTS screen, review the results of the test. The screen
shows:
– Power of the transponder signal (in dBm—power ratio in decibels of the
measured power referenced to one milliwatt).
– Measurement of the carrier-to-noise ratio, expressed as Es/No in decibels.
–Frequency offset of the transponder signal from its expected frequency
(in megahertz)
– Indication as to whether the transponder signal is above the power lock
threshold.
12 Troubleshoot any problems following the instructions provided by DIRECTV.
a To repeat the test at a different location, press CHANGE LOC.
Then go to Step 5.
b To repeat the test at a different orbital slot, press CHANGE SAT.
Then go to Step 9.
c To repeat the test at a different transponder, press CHANGE TR.
Then go to Step 10.
To repeat the test for a sequential transponder, use
c or d to change the
transponder number to the next or previous transponder. The SAT TUNE
RESULTS screen updates to show the results of the test for the selected
transponder.
13 Press DONE to return to the TEST screen.
Note: The SAT TUNE RESULTS screen
automatically updates to show the most recent
test results for the transponder.
To Next Page
Loading...
Need help?
General
