Chapter 1: Introduction
Operation Manual: Evolution Series
CAUTION: TO AVOID DAMAGING THE INSTRUMENT
• DO NOT OPERATE 6100 HEATERS WITH LESS THAN 500mL
LIQUID IN EACH VESSEL.
• THE STIRRING ELEMENT (Paddle or Basket) MUST BE
IMMERSED INTO THE LIQUID AND ROTATING WHEN
HEATERS ARE OPERATING.
• USE ONLY GLASS VESSELS SUPPLIED FOR THE EVOLUTION
SYSTEM BY Distek.
• CONNECT THIS UNIT TO THE SPECIFIED AC SUPPLY.
OBSERVE PROPER GROUNDING.
♦ FAILURE TO OBSERVE THESE PRECAUTIONS MAY DAMAGE
THE HEATER ASSEMBLIES AND/OR VESSELS.
The Evolution System is supplied with proper heaters
and settings for the specified operating voltage (see
label for information). Do not attempt to convert
unit to another mains supply without contacting
Distek's factory first!
Take care when removing or replacing vessel heaters.
Turn off unit and disconnect power from 6100. Do
not use metal tools or sharp objects to mount heater.
Heater failure and/or injury could result.
External cables (excluding power cable) are limited to less
than 3 meters length in order to maintain electromagnetic
compliance.
Some forms of electromagnetic interference may cause
unexpected operation. If this occurs, the unit will return to
normal operation once the interference is removed.
To Next Page
Loading...
