Distek Evolution 6300 - Open;View an Existing Method

Chapter 3: Operation
Operation Manual: Evolution Series
3
-
29
6. The system will automatically detect the lowering of the shaft and begin
the test. There will be a very slight delay due to the response of the unit
prior to the test starting. If this is not acceptable press ENTER at any time
after the shaft has been lower to begin the test immediately.
Open/View an Existing Method
If the operator is logged into the system with Manager
group privileges then the menu bar will contain a
selection for OPEN. If the operator is logged in with
USER group privileges then the menu bar will contain a
selection for VIEW because a USER does not have access
to modify a method.
There are 2 ways to open a method:
Method 1: Using the Auto Mode Wizard
1. From the main screen (see Figure 3-4) highlight the AUTO MODE wizard
button and press ENTER.
2. Highlight OPEN and press ENTER. The screen in Figure 3-23 will be
displayed.
3. Use the arrow keys to highlight the method from the method list and press
ENTER.
4. Highlight the menu bar item OPEN and press ENTER.
Method 2: Using the menu
1. From the main screen (see Figure 3-4) highlight the menu bar option AUTO
and press ENTER. The screen in Figure 3-23 will be displayed.
2. Use the arrow keys to highlight the method from the method list and press
ENTER.
3. Highlight the menu bar item OPEN and press ENTER.