Chapter 2: Installation
Operation Manual: Evolution Series
Quick Change Height Adjustment Knob (Paddles or Baskets)
After completing the previous setup procedure (if applicable), it should not be
necessary to move the shaft collars when switching back and forth from baskets to
paddles. Simply rotate the height adjustment knob as shown in Figure 2-9. The
extension block compensates for the difference in height paddles and baskets.
Figure 2-9: Quick Height Change Diagram
Installing the Calibration Probe
1. Make sure the serial number of the hand-held calibration probe matches the
serial number of the 6100/6300.
2. Plug in the calibration probe at the rear of the unit.
3. Place probe in holder (see Figure 2-10).
To Next Page
Loading...
